Skullbeast - building a Cylon

Post by **Skullbeast** » Wed Feb 29, 2012 10:51 am

I used an acrylic lens that I cut from flat stock. I ground the inside concave to shake the squareness of the light. The lens face was coated with rosco red ( comparable to 027 gel) sprayed, two coats. I also used a paper towel ( high tech) to be my temporary diffusion.
My problem now is the shape over all with my scanner and holder. I may try, to point the LEDs down also. ( I know you said that about the lights Dale)

Post by **Red Eye** » Wed Feb 29, 2012 2:32 pm

Thanks for this insight!

Post by **Skullbeast** » Wed Feb 29, 2012 5:18 pm

I found the one in the blue box, it's real close but a no go. An hour later I found this. I hope the scale is right, I ordered 5.

Post by **Jenne** » Wed Feb 29, 2012 5:21 pm

They look

Post by **Skullbeast** » Wed Feb 29, 2012 5:24 pm

Newark has 5mm bulbs. Hint hint! For you electronic wizards!! I think 32 in a row can be done!! I'm looking at 33 year old technology!

Post by **Skullbeast** » Wed Feb 29, 2012 5:28 pm

Cylon knight - I ordered the pnp blue. Waiting on a answer from either Dale and Jenne on 18 volt plate's exact dimensions.

YouTube · Post by **Cylon-Knight** » Thu Mar 01, 2012 12:28 pm

Skullbeast wrote:Cylon knight - I ordered the pnp blue. Waiting on a answer from either Dale and Jenne on 18 volt plate's exact dimensions.

Very good. I'll update the file when we get the size, and then rock and roll!

Post by **Jenne** » Thu Mar 01, 2012 4:58 pm

PM send
It is 2,8cm (28mm) x 2cm (20mm)

Post by **Skullbeast** » Thu Mar 08, 2012 8:31 pm

99% match

YouTube · Post by **Cylon-Knight** » Thu Mar 08, 2012 9:39 pm

Invention, my dear friends, is 93% perspiration, 6% electricity, 4% evaporation, and 2% butterscotch ripple.

99% + 2,000! Great work Skullbeast.

Post by **GoldCylon** » Thu Mar 08, 2012 10:17 pm

Damn. I'd market them G&M battery belts. What is anyone going to say. Use the small print * next to the description.

Post by **Skullbeast** » Sun Mar 11, 2012 3:32 am

Oh yeah!!! Super tough!!!

Post by **Skullbeast** » Sun Mar 11, 2012 3:37 am

Dale. Do you have dimensions for that rib extension connector? The flat stock. I seemed to have misplaced the measurements I had.

Post by **Skullbeast** » Sun Mar 11, 2012 3:58 am

Thanks for doing the plate reboot files cylon knight!

YouTube · Post by **Cylon-Knight** » Sun Mar 11, 2012 3:04 pm

Skullbeast wrote:Thanks for doing the plate reboot files cylon knight!

By Your Command.

(Now, slow down - you make me look bad!

) lol