ByYourCommand.net

I used an acrylic lens that I cut from flat stock. I ground the inside concave to shake the squareness of the light. The lens face was coated with rosco red ( comparable to 027 gel) sprayed, two coats. I also used a paper towel ( high tech) to be my temporary diffusion.
My problem now is the shape over all with my scanner and holder. I may try, to point the LEDs down also. ( I know you said that about the lights Dale)

Thanks for this insight!

I found the one in the blue box, it's real close but a no go. An hour later I found this. I hope the scale is right, I ordered 5.

They look

Newark has 5mm bulbs. Hint hint! For you electronic wizards!! I think 32 in a row can be done!! I'm looking at 33 year old technology!

Cylon knight - I ordered the pnp blue. Waiting on a answer from either Dale and Jenne on 18 volt plate's exact dimensions.

Skullbeast wrote:Cylon knight - I ordered the pnp blue. Waiting on a answer from either Dale and Jenne on 18 volt plate's exact dimensions.

Very good. I'll update the file when we get the size, and then rock and roll!

PM send
It is 2,8cm (28mm) x 2cm (20mm)

99% match

Invention, my dear friends, is 93% perspiration, 6% electricity, 4% evaporation, and 2% butterscotch ripple.

99% + 2,000! Great work Skullbeast.

Damn. I'd market them G&M battery belts. What is anyone going to say. Use the small print * next to the description.

Oh yeah!!! Super tough!!!

Dale. Do you have dimensions for that rib extension connector? The flat stock. I seemed to have misplaced the measurements I had.

Thanks for doing the plate reboot files cylon knight!

Skullbeast wrote:Thanks for doing the plate reboot files cylon knight!

By Your Command.


(Now, slow down - you make me look bad! ) lol